Manufacturer Description

The RAM-HOL-GA12 High Strength Plastic Cradle is designed to hold the Garmin GPS 60, GPSMAP 60C, GPSMAP 60Cx Series and Garmin Astro GPS Series. This includes the following Garmin GPS units,

• Garmin GPS 60,
• Garmin GPSMAP 60,
• Garmin GPSMAP 60C,
• Garmin GPSMAP 60CS,
• Garmin GPSMAP 60Cx,
• Garmin GPSMAP 60CSx,
• Garmin Astro 220 Series.

Placing Your Garmin GPS into the Cradle: 
First you need to attach the round belt clip button that is included with the purchase of the GPS unit, to the back of your unit. Next, place the bottom of the GPS into the cradle, and then clip the top of the cradle over the round button (previously attached) on the back of the GPS.

Included with the Garmin GPS Cradle: The cradle includes a set of two nuts and bolts to connect the cradle to any of the RAM compatible mounts.

Garmin GPS Mount Options: 
To help ensure you have the Garmin GPS 60, GPSMAP 60CS, GPSMAP 60CSx or Garmin Astro Series Mount you require, take a look at the list of available RAM Garmin GPS mounts on the Garmin GPSMAP 60CSx Mount Page or the Garmin Astro 220 Mount Page. Here you can select from suction cup GPS mounts, flat surface screw down GPS mounts, GPS car mounts, non skid weighted GPS mounts and more bundled with the RAM-HOL-GA12 Garmin GPS 60, GPSMAP 60CS, GPSMAP 60CSx or Garmin Astro Series Cradle.

Important Mounting Information: 
If you already own this cradle, or any other cradle with a hole pattern that will match the RAM Diamond Plate hole spacing, then you require one of the RAM Assemblies listed below. If you are looking to purchase a complete mount for the above cradle, take a look at the Complete Mount list below.

This cradle does not ship with a RAM ball. To add a 1 inch ball to this cradle you need to purchase either the Aluminum Diamond Plate with 1 inch ball (RAM-B-238) or Plastic Diamond Plate with 1" ball (RAP-B-238). If you need to mount this cradle on a 1.5" ball system, you will require the Aluminum Diamond Plate (RAM-238).